Jason Voorhees - Hueforge

🔪 Jason Voorhees | 100x200 HueForge

"Ki ki ki... ma ma ma..."
 

Here's my take on Jason Voorhees in HueForge form. I wanted to keep this one simple with a clean color pop style using black, gray, white, and red. The bold red on the mask and machete stands out nicely against the grayscale, giving it that classic horror movie look without overcomplicating the print.

This is a 100 x 200 mm HueForge that uses only Bambu Basic PLA. It prints with four colors and three manual filament swaps, making it an easy project whether you're using an AMS or swapping filament by hand.
 

Hope you enjoy printing it as much as I enjoyed making it!

NOTE:

If you want to resize this DO NOT resize Z. It will mess up the layers.

🧵 Filaments Used

All colors are Bambu Basic PLA

• 🖤 Black
• 🔹 Blue Grey
• 🤍 White
• ❤️ Red

🔄 Print Instructions

Pause and swap filament at the following heights:

• 0.00 mm → Black
• 0.72 mm → Blue Grey
• 0.80 mm → White
• 1.28 mm → Red (print remaining layers)

I’d love to see your results! Please consider uploading a make and leaving a rating if you enjoy the model. If you like this model, please don't forget to hit that Thumbs Up 👍 and Boost 🚀 button and check out my other work!