Key Ring Helper V2

Please read description 

This model is version two of my key ring helper, made for making the process of adding/removing stuff from a key ring easier and less painful! Simply push the helper in between a key ring, which separates it, allowing you to easily slid in whatever you need. Ridges on the helper “catch” the ring, allowing it to fit securely as you slide in a key or key ring. These are spaced at different heights, allowing you to open the ring to however large you need. Gone are small ridges for your fingers to grip, now replaced by a curved surface to push against. Included are two versions, one basic, one with a piece that goes on a key ring, and then the main helper clips into it. This allows you to carry the key ring helper with your keys, then easily take it off when needed! This model also uses less than 2 grams of filament, making it perfect if you have a small bit of filament left on a spool!

It is important to note that the clip on the connector will be tight at first, but will loosen after clipping it in a few times.  I highly recommend not messing with settings, especially the adaptive layer height setting, which has been fine tuned for the best strength, but also smoothness for easy use. Happy printing!