A 26mm spacer for the lid on an Eibos Cyclopes drybox. This allows you to route the filament through the spacer instead of the lid making the lid simple to remove. I truly hated the original design when using two spools.

BOM:

-printed spacer, must be printed in ABS/ASA to prevent warping when drybox is heating

-two M3 threaded inserts (Voron spec)

-two M3x8 screws

-two PC4-M10 pneumatic fittings

Two 3mm holes need to be drilled on the drybox if you wish to mount the spacer with screws. Not really necessary though :)

Fits on a Bambu print bed and prints beautifully in three hours.