Search models, users, collections, and posts
Mario Question Block Clicker
IP Report
GIF
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
9 h
5 plates
Open in Bambu Studio
Boost
34
68
0
1
10
1
Released
Description
Content has been automatically translated.
a boost or a like would help me a lot
thank you
first of all, apologies for the dirt on the railing where I took the photo hahaha, but the clicker is beautiful, no printing errors, no supports needed, and it comes in parts. It uses a standard mechanical key switch, (it's like keyboard clickers or the most commonly used ones, I'll leave a reference image of the clicker used and its purchase page-IMPORTANT TO NOTE: well-dried filaments, a very clean print bed, and do not change parameters as it is set up for full quality printingregarding the mushroom, there are two options, one with a two-part connector and another for printing with 4 colorsthank you for the support
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)