Search models, users, collections, and posts
Sonos AMP elevador
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.8 h
2 plates
Open in Bambu Studio
Boost
0
0
0
0
0
0
Released
Description
Content has been automatically translated.
Raises your Sonos AMP by 45mm, it is ideal for cooling if you have several AMP amplifiers and want to stack them, leaving space between amplifiers and preventing overheating.
I have seen other risers, but these precisely covered the area where the amplifiers breathe. I have designed this riser precisely avoiding that problem, it is also prepared to be screwed to the amplifier so that it does not fall or move. In addition, I have left a small notch underneath to be able to stick a small 3mm anti-slip rubber so that it does not slide on the furniture or on top of another AMP.
I recommend printing in PETG, as PLA could deform with the heat emitted by the amplifiers.
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (0)