P2S Risers, simple quick sturdy

I couldn't find any small, simple risers which seemed to hold the glass well (with raised edges), so I knocked up some of my own. Thought I would share in case anyone was looking. They sit inside the top of the P2S, and also widen to fully hold the glass inside their edges for a snug, sturdy fit. They have chamfers so no support is necessary.

They give 25mm of raise, enough for the PTFE tube to clear the glass without any mods to it. They have a honeycomb infill with no top and bottom layers, just because why not…. Other than that, the profile is just for basic PLA. I used PLA Sparkle from Elegoo.

Quick print on 0.2mm layer height.

Back radius is probably about 1mm off but they do the job perfectly so I didn't go back and change it - I've included the F3d file for anyone who wants to fully modify.