Bambu Labs Filament Cutter - Remix
Remixed by
Copyright Claim
Bambu Labs Filament Cutter - Remix
Remixed by
Boost
5
7
3
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
50 min
1 plate
Boost
5
7
3
0
16
8
Released
Description
I loved the design by BC Designs https://makerworld.com/en/u/1589689919
Just needed it to cut filament already in the extruder on my other printers so I put a slot in the side. I have also added a sacrificial support for the screws which you can remove with a drill bit easily. Please see the original post for all the hardware needed.
****WARNING****
This does require supports for the slot AND I can't stress enough that you could stab yourself trying to remove them. I had a couple of close calls and some clenching of the buttocks but got through it unscathed…..lol
Comment & Rating (3)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
(Edited)
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld