Snack Bowl / Snack Dish / Snack Plate
Copyright Claim
Snack Bowl / Snack Dish / Snack Plate
Boost
48
96
18
Print Profile(14)
3 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
Designer
3.4 h
1 plate
5 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
Designer
3.8 h
1 plate
5 outer Slots / 1 inner Slot / 0.16mm layer, 50% infill
Designer
5.8 h
1 plate
4 outer Slots / 1 inner Slot / 0.16mm layer, 50% infill
Designer
5.7 h
1 plate
Click to see more
Open in Bambu Studio
Boost
48
96
18
1
151
125
Released
Description
This stackable bowl has a diameter of 22cm, a height of 3cm and is available in different divisions.
This shell is best printed with PETG. Most PETG filaments are suitable for food. Also they can be put in the dishwasher. However, it depends on the manufacturer and filament.
I use a Bambu Lab X1C for printing and the tray prints in 3-4 hours depending on the number of dividers chosen.
Comment & Rating (18)
All
Print Profile
3 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
1
Reply
Print Profile
4 outer Slots / 1 inner Slot / 0.16mm layer, 50% infill
1
Reply
Print Profile
4 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
0
Reply
Print Profile
5 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
0
Reply
Print Profile
5 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
love these good test for Petg
1
Reply
Print Profile
5 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
1
Reply
Print Profile
3 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
0
Reply
Print Profile
5 outer Slots / 1 inner Slot / 0.16mm layer, 50% infill
0
Reply
Boosted
Print Profile
5 outer Slots / 1 inner Slot / 0.2mm layer, 50% infill
0
Reply
Print Profile
5 outer Slots / 1 inner Slot / 0.16mm layer, 50% infill
Strength Issue: I found the walls a bit to be way too thin so thin as a matter of fact that it printed with a hole.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld