Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
4 h
3 plates
Thinner Easier Assembly 0.2mm layer, 2 walls, 15% infill
Designer
3.8 h
3 plates
Boost
26
47
7
0
38
75
Released
Description
A rustic lantern design that requires no glue to assemble.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
It will be beautiful IF I can ever get it together. This is an absolute pain in the ass to assemble. I will admit part of the frustration is definitely my fault for not noticing the nozzle for this 3mf is set to 0.4, but when I went back and reprinted parts with the correct nozzle I still am fighting the assembly. At this point I may just reprint it all and very slightly shrink the connecting walls but I also may just say to hell with it and throw it in the trash!
The designer has replied
0
Reply
I intentionally made it a close fit so it wouldn't require glue. I used a small hammer to tap the piece together gently once they were aligned. everything went together fine. You could scale everything down .2 mm for tolerance as well. Sorry for your troubles.
(Edited)1
Reply
Replying to @lindnjoe
Thanks for the response! I really wanna make this works so I may just try that :)
0
Reply
Replying to @rache6987
I uploaded a version that is .2 mm shorter to hopefully make it easier to assemble.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
tough to get the pieces to fit together without lots of sanding.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice lantern!!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld