Thin layers scraper (tiny+ergonomic) (with magnet)
Remixed by
Copyright Claim
Thin layers scraper (tiny+ergonomic) (with magnet)
Remixed by
Boost
20
49
13
Print Profile(5)
(Adaptive Layer Height) 0.16mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
0.08mm layer, 2 walls, 15% infill
46 min
1 plate
0.12mm layer, 2 walls, 20% infill
31 min
1 plate
0.2mm layer, 6 walls, 100% infill
27 min
1 plate
Click to see more
Open in Bambu Studio
Boost
20
49
13
2
239
71
Released
Description
I remixed the Thin layers scraper (tiny+ergonomic) from SH to add a magnet so I could hang it from my X1 Carbon.
The STL is designed for a tight fit using an 8mm x 3mm magnet but I have included a parameterized Fusion 360 file if you want to use a different sized round magnet or need to adjust the tolerance.
Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.
If you like this project, please don't forget to ❤ Like and ★ Rate!
Comment & Rating (13)
All
Print Profile
(Adaptive Layer Height) 0.16mm layer, 2 walls, 15% infill
does its job
0
Reply
Print Profile
0.12mm layer, 2 walls, 20% infill
Love this little guy for removing stuff from the print bed.
0
Reply
Amazing scraper, my favorite!
Printed in PLA like a noob then realized it should be in PETG for strength! Made it bigger too.
(Edited)
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0.08 is likely smaller than needed
0
Reply
Print Profile
0.12mm layer, 2 walls, 20% infill
0
Reply
Print Profile
(Adaptive Layer Height) 0.16mm layer, 2 walls, 15% infill
Worked out perfectly on eSun PLA+
0
Reply
This is a very useful little one indeed！
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
works OK for PLA but it battles a bit when trying to get off filament thatis stuck down good(where your release layer glue has worn off for instance)
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Love the little round scraper.
Use variable layer heights to greatly reduce print time.
(Edited)0
Reply
Print Profile
(Adaptive Layer Height) 0.16mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld