I designed this door vent in order to be able to prop the door open for more chamber cooling. This reduces the noise from the printer but allows increased airflow.

8mm x 3mm round magnets are used to secure the vent to the door, to the printer, and (optionally) to the side printer while not in use. Each magnet hole is ~6mm deep so they can be double stacked for strength.

The magnet on the edge that touches the frame of the machine attaches to a magnet inside the frame of the printer so you will need to pay attention to the correct orientation of that magnet.

Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.

If you like this project, please don't forget to ❤ Like and ★ Rate!

Printing tips

• Material and layer height aren't that important
• Print with the hex grid touching the build plate
• Support is required along the edge that touches the printer

Updates

• 2023-04-08
  • Added MAGNET_TOLERANCE with a value of 0.1mm to the magnet holes and depth for easier insertion (thanks for catching this @DominikJezior_641266)