Mounting Hardware for Ikea Skadis Pegboard
Copyright Claim
Mounting Hardware for Ikea Skadis Pegboard
Boost
39
135
7
Print Profile(1)
0.16mm layer, 4 walls, 25% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
39
135
7
0
93
48
Released
Description
I wasn't happy with the mounting hardware that comes with the Ikea Skadis Pegboard. The screws stuck out too far which interfered with mounting things on the board. Additionally it only comes with two bottom pegs so the center is not well supported. So I designed these as replacements.
Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.
If you like this project, please don't forget to ❤ Like and ★ Rate!
Required Hardware:
(2) M4 x 12mm button head screw
(2+) M2 x 14mm socket head screw (one per bottom mounting peg)
(2+) M2 x 3.0mm L x 3.6mm OD or (4) M2 x 4.0mm L x 3.6mm OD heat set insert (one per bottom mounting peg)
* Some of the links above are Amazon Affiliate links
Comment & Rating (7)
All
Print Profile
0.16mm layer, 4 walls, 25% infill
printer as expertråd with PLA, fits
The designer has replied
0
Reply
Those look great! Hope you enjoy using them.
0
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld