Glow Effect Skull Keychain
Glow Effect Skull Keychain
Boost
16
32
6
Print Profile(1)
0.04mm layer, 1 walls, 100% infill
Designer
45 min
1 plate
Boost
16
32
6
0
19
16
Released
Description
Cute little skull keychains that use filament layer swaps to create an ‘X-ray’ or glow effect. Fun little gifts for Halloween, or for the general horror enthusiast!
You can swap out the colours for other colours if you prefer - just replace green with the colour of your choice.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.4
- PLA BambuLab Basic BambuLab Green Transmission Distance: 8
- PLA Kingroon White Transmission Distance: 8
Swap Instructions:
- Start with Black
- At layer #24 (1.08mm) swap to BambuLab Green
- At layer #35 (1.52mm) swap to White for the rest.
Comment & Rating (6)
All
Print Profile
0.04mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.04mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.04mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.04mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.04mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.04mm layer, 1 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld