Break Time for Moma Kitty (HK Inspired Piece)

As a father of two I can appreciate all the hard work moms (and parents as a whole) have to do when the little ones are young and you're just looking towards nap time for a quite ten or fifteen minutes. Recently my wife's cousin came to visit us for a while and she's always been a fan of the series and is going through the same thing a lot of us have so I figured I'd cheer her up and make this for her.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.32mm and the Actual Thickness is 2.24mm

    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.1
    #ff9016 PLA BambuLab Basic Pumpkin Orange  Transmission Distance: 5.5
    #ff0000 PLA BambuLab Basic Red  Transmission Distance: 4
    #e8afcf PLA #BambuLab Matte Sakura Pink  Transmission Distance: 2.4
    #56b7e6 PLA BambuLab Matte Sky Blue  Transmission Distance: 1.3
    #f7d959 PLA #BambuLab Matte Lemon Yellow  Transmission Distance: 4
    #eaffff PLA BambuLab Matte Ivory White  Transmission Distance: 3.4
This print uses 7 unique filaments

Swap Instructions:
    Start with BambuLab Basic Black
    At layer #10 (0.88mm) swap to BambuLab Basic Pumpkin Orange
    At layer #13 (1.12mm) swap to BambuLab Basic Red
    At layer #15 (1.28mm) swap to #BambuLab Matte Sakura Pink
    At layer #17 (1.44mm) swap to BambuLab Matte Sky Blue
    At layer #19 (1.6mm) swap to #BambuLab Matte Lemon Yellow
    At layer #23 (1.92mm) swap to BambuLab Matte Ivory White for the rest.