Aerosmith Coasters

Aerosmith Coasters

These coasters are larger than most of the other coasters I have done. I have created  a special holder to hold them. 
The coasters are approximately 150mm x 100mm x 4mm

I put two coasters on a plate which should be just fine if you have a printer like the X1C, P2S or A1. If you have a Bambu H2S you can put four coasters on the plate which will save you some time

These are the cork adhesive backings that I used from Amazon   https://a.co/d/0eCIbe88/  These are 15cm square and 2mm thick. I made the height of the coaster holder 28mm high to accommondate the coasters with the cork backing. If you use a thinner cork backing then you will have to change JUST the height

Take a look at my other railroad and non-railroad coasters and clocks at https://makerworld.com/en/@railimages