Shell Bead Tray
Print Profile(2)
Description
Boost Me (for free)
Thank you very much!
Introduction:
Two double circles are for a 16cm wrist circumference
Two long strips are for a 19cm wrist circumference, with 1cm scale intervals
The groove width is 9.5mm. Beads 9mm and smaller can be fully embedded, and beads larger than 9mm can also be held, making it widely practical
Printing notes:
【Single color version】suitable for most printer models (Sorry A1 mini, this is too big to print)
【Dual color version】suitable for dual-head or multi-head models like H2D, H2C, not recommended for single-head printers, color changes waste a lot of filament
Drawbacks:
To maintain gloss and stability, special supports were created. When removing them, try not to pull back and forth. You can carefully cut the connection points with sewing scissors or cuticle nippers,
After support removal, it's hard to avoid small dot-like imperfections on the back of the bead tray, which does not affect usability
Finally, check out the GIF, it's very beautiful!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)