Stackable Storage Container

Be sure to read the introduction below. To ensure quality, it is recommended to print from a computer and use your own filament's print parameters. If you cannot ensure strong bed adhesion, it is recommended to apply glue.

Stackable Container organizer

1️⃣ Print Files Introduction

The print files are divided into three parts

1. Stackable Container organizer 85: The height of the box when stacked is 85mm. This file includes the shell + drawer.
2. Top Lid: The top layer requires a lid, otherwise it doesn't look good.
3. Logo: Currently, only a McDonald's logo has been made. If you need any other logos in the future, you can leave a comment in the comment section to contact me.

2️⃣ Important Notes ⚠️ Must Read

1. Printing large square boxes is prone to warping, especially with open printing and low ambient temperatures. It is recommended to apply glue and avoid using high-shrinkage filaments. You need to choose your own filament, I cannot change this physical law!!!
2. I have set many yellow modifiers in the file, do not move them! The entire model basically requires no infill. I have optimized the 3mf to the best, requiring no extra infill due to physical laws. If you delete them, printing will waste a lot of filament and be very slow.
3. The LOGO needs to be adhered with glue or Blu-Tack.
4. The external dimensions of the organizer are 248x165x85 mm, and the actual storage height is 80mm. If you need other dimensions (length, width, height), you can private message me.
5. I printed it myself using PLA, with the official PEI textured plate, cleaned thoroughly, without applying glue, at 75 degrees Celsius, and had no issues. Slight warping of 1-1.5mm does not affect usability.