Snail Tape Dispenser
Snail Tape Dispenser
Boost
16
10
4
Print Profile(1)
0.16mm layer, 2 walls, 20% infill
1.1 h
1 plate
Boost
16
10
4
0
14
5
Released
Description
Printed with Bambu Lab X1 carbon.
Layer height 0.16 mm, but anything is fine.
Infill 20%
Ironing on top surface.
For the blade I used one from an old dispenser.
Below are the dimensions of the blade:
Below are the dimensions of the tape used:
Comment & Rating (4)
All
Hi there! Great design, but can you please provide the measurements as to what size scotch would fit there? Thank you in advance!
The designer has replied
1
Reply
Hi @KonnyK, thank you.
The scotch I use has:
- Width: 19mm
- Inner hole diameter: 25mm
- External diameter: max 55 mm
I add a photo to the description
0
Reply
Does the blade just sit loose in the unit? What did your blade look like? - I'm not sure if they are universal so just want to check.
The designer has replied
1
Reply
Hi, the blade I used was from an old tape dispenser. It's only stuck in the 3D printed dispenser. if you want you can add a little glue.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld