Gohan Ascending - DBZ Hueforge

⚫⚪🔴🟡

🔥Only 4 Colors this time!🔥

"GOHAN ASCENDING"

Here we are again. A small change of pace. Saying this was one of my all time favorite anime sounds reduntant to most fans of the genre 😅. But this was one of my ALL TIME FAVORITE anime growing up! Y'all remember coming home from school so eager to catch the next 20 minutes, only to have them scowl a lot and you find out the fight will actually start tomorrow? 😭🤣

And we all remember when this kid finally gave us our first five minute reprieve from his whining and crying? I know we all just focus on how cool he gets whenever we rewatch it. 

Well it doesn't get more straightforward than this one 😎.

Set it, forget it, do what you do. Hope you love it! 👋

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 3.04mm and the Actual Thickness is 3.04mm

    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Jade White  Transmission Distance: 5
    PLA BambuLab Basic Yellow  Transmission Distance: 6
    PLA BambuLab Basic Red  Transmission Distance: 4

This print uses 4 unique filaments 😽   (Please note Transmission Distance when making Brand substitutions, especially with WHITE and YELLOW. My hueforges are all about blending, and if you use white that doesn't transmit enough light, then you will not have skin color.)

Swap Instructions:

    Start with Black
    At layer #6 (0.56mm) swap to Jade White
    At layer #14 (1.2mm) swap to Black
    At layer #15 (1.28mm) swap to Yellow
    At layer #21 (1.76mm) swap to Jade White
    At layer #22 (1.84mm) swap to Yellow
    At layer #25 (2.08mm) swap to Black
    At layer #26 (2.16mm) swap to Red
    At layer #33 (2.72mm) swap to Yellow
    At layer #35 (2.88mm) swap to Jade White for the rest.