stand lamp

steps are easy to follow first you will need 4 items light bulb, wire with minimum 2.5 meters , and the item where you screw light bulb (dont know name sorry it is in the photo), and then glue i was using bison glue for plastic and the follow instructions for easier assemble,

1. print everything at first then start assemble

   make ready for stand with 4 legs 

2. legs
3. and then put wire trough
4. then pick up thos small blue items and then glue them inside 4 holes
5. take a stand and there is numbers on the stand start from 1 and number will always face up if you put it facing down its okey and if you mix numbers its also okey just make sure last numbers are last and when you put stand remember put wire trough
6. after you put stand last one will be with big hole 
7. then start assemble the ball make sure you put wire and and you will need to get ready the light bulb if you dont have where you can screw the light bulb that plastic where you wire your wires you can without thread just glue it without thread 
8. and the n start assemble ball doesnt matter how you start i was starting from bottom and i glued them togather bottom half i mean and then i make everything where is light bulb 
9. if you want you can glue everything togather after both sides is ready bottom and top but it will hold very thigh 
10. after you done everything i know i said dont glue everything but you will need to glue those thin items 
11. after everything is done you have lamp