Herb Stripper
Print Profile(1)
Description
Description
Tired of picking off parsley leaves one by one, oregano getting everywhere? This simple device solves all your herb related problems. It features four holes of differing sizes, designed for you to feed your herbs through and effortlessly remove the leaves from the stem. Once the leaves are stripped they neatly fall into the basket keeping them contained, and your counters clean. Also, did I mention, it only uses 7 grams of filament! Meaning you finally have a use for all those almost empty rolls you have lying around.
Printing & Food Safety
By default the model is set to print in PETG, as it's generally considered food “contact” safe. Despite this you can switch to any filament you have and Bambu Handy will adjust the settings for you. If you're gonna be using this regularly I would highly recommend Bambu Lab PLA Pure. (I don't have any PLA Pure yet so was unable to try this) However, any filament should be fine as long as you wash the Herb Stripper before use, and rinse your herbs off before cooking. Which you should be doing anyway.
Dimensions
The model in 9cm tall, 3.5cm wide, and 5cm deep. The holes are 1mm, 3mm, 5mm, and 7mm in diameter. If the 1mm hole becomes sealed, adjust the XY hole compensation until it opens up. Different filaments have different shrinkage rates, and your mileage may vary.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)