Jinx Hueforge

Project: Jinx_V3_7colors.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 114.87x162.6mm in size

You may print at higher layer heights below the Base Thickness of 1.52mm

The Max allowed Thickness is 3.52mm and the Actual Thickness is 3.52mm

Filaments Used: (* = Owned)
#000000 PLA Sunlu Meta Black Transmission Distance: 1
#4c5f71 PLA BambuLab Basic Blue Gray Transmission Distance: 3
#00358e PLA BambuLab Basic Blue Transmission Distance: 4
#ffffff PLA Sunlu Meta White Transmission Distance: 8
#f5547c PLA BambuLab Basic Hot Pink Transmission Distance: 3.9
#ff9016 PLA BambuLab Basic Pumpkin Orange Transmission Distance: 5.5
#fce300 PLA BambuLab Basic Yellow Transmission Distance: 6

This print uses 7 unique filaments

Swap Instructions:
Start with Black
At layer #23 (1.92mm) swap to Blue Gray
At layer #25 (2.08mm) swap to Blue
At layer #27 (2.24mm) swap to White
At layer #29 (2.40mm) swap to Hot Pink
At layer #31 (2.56mm) swap to Pumpkin Orange
At layer #33 (2.72mm) swap to Yellow
At layer #35 (2.88mm) swap to White for the rest.

For only one AMS, start with 4 colors as follows:

Slot 1: Black
Slot 2: Blue Gray
Slot 3: Blue
Slot 4: White

Pause has been added and swap filaments as follows:

Slot 1: Black → Hot Pink
Slot 2: Blue Gray → Pumpkin Orange
Slot 3: Blue → Yellow