Ceramic stamp - Luck
Print Profile(0)
Description
Ceramic stamp Luck, designed to make a clean impression on clay
Every decision for this stamp was made with the moment it touches the clay in mind, not just its screen appearance.
The design is mirrored, so the word appears correctly when you press it into the clay, without inversion.
The relief depth is 0.5mm, calibrated to mark sharply without tearing the clay. The flat base around the letters acts as a depth support, helping to maintain a uniform impression with each use.
The face that touches the clay is printed face up and receives a smoothing pass on top. This leaves the contact surface smooth, with few layer lines, and transfers the mark clearly.
The layer height is low, which keeps the edges of the cursive letters defined and the contours clean, without coarse stepping.
The body is printed with reinforced walls, a solid top, and gyroid infill. Result: the stamp does not yield or deform under firm hand pressure, mark after mark.
The print seam is hidden at the back, away from the working face, to avoid leaving an unsightly spot in the important area.
No supports in the relief area, so the letters come out with integral detail, without removal marks.
The base has rounded corners, comfortable to hold and press, and releases cleanly from the clay without digging in at the edges.
Approximate size: 50 x 34mm base, 5mm height. Printed in PLA.
A stamp designed to impress deeply, release cleanly, and repeat the same result time after time.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)