Duke Nukem - We Were Heroes Once (WWHO) - Part 2/9

Ok, so part 2 of my We Were Heroes Once Series (WWHO)! 

I apologize as I know this one might be a little more crass than my usual uploads, buuuut let's be honest, Duke couldn't just retire off into the sunset and not have a girl or two with him and let's be honest, he'd still be smoking 10 cigars a day even long past his face turning into a wrinkled catchers mit and his blond hair has turned into a shade of white. This one is one of the more light hearted, but buckle up as I gaurantee some of these might hit a little harder than our old boy Duke over here. 

Project: Reset .hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.56mm
The Max allowed Thickness is 2.32mm and the Actual Thickness is 2.32mm

    #000000 PLA #BambuLab Basic Black  Transmission Distance: 0.6
    #042f56 PLA BambuLab Matte Dark Blue  Transmission Distance: 0.2
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
    #f99963 PLA BambuLab Matte Mandarin Orange  Transmission Distance: 3.2
    #fec600 PLA BambuLab Basic Sunflower Yellow  Transmission Distance: 4.5
    #eaffff PLA BambuLab Matte Ivory White  Transmission Distance: 3.4
This print uses 6 unique filaments

Swap Instructions:
    Start with #BambuLab Basic Black
    At layer #9 (0.8mm) swap to BambuLab Matte Dark Blue
    At layer #12 (1.04mm) swap to BambuLab Basic Red
    At layer #15 (1.28mm) swap to BambuLab Matte Mandarin Orange
    At layer #16 (1.36mm) swap to BambuLab Basic Sunflower Yellow
    At layer #19 (1.6mm) swap to BambuLab Matte Ivory White
    At layer #21 (1.76mm) swap to BambuLab Matte Mandarin Orange
    At layer #23 (1.92mm) swap to BambuLab Matte Ivory White for the rest.