Xbox One controllers stand
Xbox One controllers stand
Boost
42
85
29
Print Profile(2)
Original 0.28mm layer, 3 walls, 10% infill
Designer
2.6 h
2 plates
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Boost
42
85
29
0
210
205
Released
Description
Stand for two Xbox One controllers with logo.
Comment & Rating (29)
All
Works great, no real issues. I would personally prefer the controllers to lean backwards a little, again, not an issue.
The designer has replied
1
Reply
Thanks 👍🏻
0
Reply
Print Profile
Original 0.28mm layer, 3 walls, 10% infill
Printed good and is holding my Xbox controlers vertically on small table. A+
1
Reply
Print Profile
Original 0.28mm layer, 3 walls, 10% infill
stand object set on to high speed, that cause artifact on corner near logo, and its may logo parts not fit in hole
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Clean print, looks good, takes up minimal horizontal space.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
i wish you had included the glue in inserts for the logo
The designer has replied
1
Reply
Yes 👍🏻
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ok
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfekt print with this profile
1
Reply
Print Profile
Original 0.28mm layer, 3 walls, 10% infill
worked perfectly and much more organized now
0
Reply
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld