Wahoo ELEMNT BOLT V2 mtb mount for 35mm handlebar
Copyright Claim
Wahoo ELEMNT BOLT V2 mtb mount for 35mm handlebar
Boost
8
12
5
Print Profile(2)
0.12mm layer, 3 walls, 15% infill
Designer
2.2 h
1 plate
0.12mm layer, 2 walls, 15% infill
Designer
2.5 h
1 plate
Boost
8
12
5
0
33
16
Released
Description
I have adapted the original mount from Wahoo to the 35mm handlebar of my Specialized MTB.
The printing orientation is needed for streng at the pin location.
Update 17.04.2024:
I reduced the holes in the model, since most of them come from the injection modling for the original part. Not need for 3d printing. So now its way easier to print. Less support and reduced the print time to 2.5h.
Necessary parts:
- M4 heat insert or nut
- original M4 screw from the bracket of the Roam V2
- cover from the original bracket
- metal pin from the original bracket
- optional: protection for the handlebars
Comment & Rating (5)
All
Du you know by chance if this could be mounted on there as well? https://makerworld.com/models/452722
The designer has replied
0
Reply
Since this is mounted by drilling hole in something, technical yes! :D But would not recommend. You can probably just merge this two prints together with tinkercad.
1
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
Support Issue:print was good but supports almost impossible to remove.
The designer has replied
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld