Naruto Headshot - Hueforge

   I know there isn't exactly a shortage of Naruto out here, but I still plan to get my feet wet with the Big 3 from time to time! Believe it..😎

I'll basically get right to the print since we could all probably write our own descriptions of this landmark in the medium 💕.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 3.44mm and the Actual Thickness is 3.44mm

    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Red  Transmission Distance: 4
    PLA BambuLab Basic Yellow  Transmission Distance: 6
    PLA BambuLab Basic Jade White  Transmission Distance: 5
    PLA BambuLab Basic Blue  Transmission Distance: 4

This print uses 5 unique filaments. (Please note Transmission Distance when considering brand substitutions. Especially with WHITE and YELLOW.)

• Non AMS and Multi AMS Users. Delete my programmed pause on layer 14 and do your thing as usual.
• SINGLE AMS USERS. Only a single easy swap to print with one unit. Follow the Guide below.

Swap Instructions:

    Start with Black
    At layer #2 (0.24mm) swap to Red
    At layer #3 (0.32mm) swap to Yellow
    At layer #10 (0.88mm) swap to Red
    At layer #11 (0.96mm) swap to Black
    At layer #13 (1.12mm) swap to Jade White
    At layer #20 (1.68mm) swap to Blue
    At layer #26 (2.16mm) swap to Red
    At layer #31 (2.56mm) swap to Jade White
    At layer #33 (2.72mm) swap to Red
    At layer #38 (3.12mm) swap to Yellow
    At layer #40 (3.28mm) swap to Jade White for the rest.