Star Wars Book Ends
Star Wars Book Ends
Boost
30
66
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10 h
2 plates
Open in Bambu Studio
Boost
30
66
3
0
44
22
Released
Description
Thought I'd make a themed bookend. This is my first version. Need to glue the base to the body. Its a little hard to glue them square but it can be done. I'll design another that will be a lot easier to glue but thought I put this one up for now.
V2
Added a slot in the body and a tab in the base to make it easier to glue. Haven't tried it yet but it should work. I allowed for 0.2mm gap incase peoples printers aren't too dialed in.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
notch in the base could use tweaking to be a snugger fit. it's great for alignment, but didn't hold the prices anywhere near together
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
awesome!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld