Nintendo Switch Controller Stand with logo
Remixed by
Copyright Claim
Nintendo Switch Controller Stand with logo
Remixed by
Boost
16
35
9
Print Profile(3)
0.2mm layer, 3 walls, 10% infill
Designer
7.1 h
1 plate
0.16mm layer, 3 walls, 10% infill
Designer
2.6 h
1 plate
0.16mm layer, 3 walls, 10% infill
Designer
8.7 h
1 plate
Boost
16
35
9
0
68
34
Released
Description
THX @ https://www.printables.com/de/@Plaground3d i added the switch logo
print set is 15-20% infill and 0,16 -0,2 mm layer high
if you need use Tree Support for the logo
Comment & Rating (9)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
Very good model, but I wish the logo could be printed seperatly from the actual controller stand.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Printed two times with royal purple and crimson red from bambulab pla sparkle fillament. looks very great. Works only with original Nintendo Pro Controller not with third Party Equipment
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld