Tink by the Water in Color Hueforge

Project: Tink by the Water_V2_7Colors.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 130.13x162.6mm in size

You may print at higher layer heights below the Base Thickness of 1.52mm

The Max allowed Thickness is 3.52mm and the Actual Thickness is 3.52mm

Filaments Used: (* = Owned)
#000000 PLA Sunlu Meta Black Transmission Distance: 1
#0056b8 PLA BambuLab Basic Cobalt Blue Transmission Distance: 1.2
#00ae42 PLA BambuLab Basic BambuLab Green Transmission Distance: 2
#ff9016 PLA BambuLab Basic Pumpkin Orange Transmission Distance: 5.5
#fec600 PLA BambuLab Basic Sunflower Yellow Transmission Distance: 4.4
#fce300 PLA BambuLab Basic Yellow Transmission Distance: 6
#ffffff PLA Sunlu Meta White Transmission Distance: 8

This print uses 7 unique filaments

Swap Instructions:
Start with Black
At layer #21 (1.76mm) swap to Cobalt Blue
At layer #23 (1.92mm) swap to BambuLab Green
At layer #26 (2.16mm) swap to Pumpkin Orange
At layer #30 (2.48mm) swap to Sunflower Yellow
At layer #34 (2.80mm) swap to Yellow
At layer #37 (3.04mm) swap to White for the rest.

For only one AMS, start with 4 colors as follows:

Slot 1: Black
Slot 2: Cobalt Blue
Slot 3: BambuLab Green
Slot 4: Pumpkin Orange

Pause has been added and swap filaments as follows:

Slot 2: Cobalt Blue → Sunflower Yellow
Slot 3: BambuLab Green → Yellow
Slot 1: Black → White