Slight tweak of Jeff Chen's excellent Dreamcast VMU AAA Battery Pack.

The bottom of each half was flattened and widened to allow for vertical printing. Supports are still necessary, but fewer are required and they will be easier to remove. In addition, the support positions will be away from the grooves and channels for the battery contacts and the wires. The cover over VMU battery compartment will be left unmarked by supports.

Tree supports work very well.

The logo was converted from an “outie” to an “innie” so it would not require supports. I might make a separate logo piece to fit the hole and allow for a different color.

The holes for the nuts and screw heads were widened because the original's were slightly too small with my printer/filament combo.

The lower holes use 16mm M2 screws and the top use 20mm.

Follow the assembly instructions of the original model. The battery cover and the optional battery separators are unchanged and not included here.