Greg Sanford

cover

plate_1.png

IMG_3486 copy.webp

0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill

PrintMason23

20231121_004539.webp

20231121_004547.webp

20231121_004946.webp

plate_1.webp

Problem: Needed to have somewhere to rest the dish sponge. Sink configuration has been limiting. I liked the idea but didn't fit where it would make the most sense, behind the faucet mount. So, needed to make slight changes to the model.&nbsp;Solution Keep model design as is, slight slant is great for draining water off aftr washing dishes up. Reduced the width (height in print orientation) and used lightning infill. Should be sufficient for use case and to save filament. Works well so far, will keep my eye out for any potential opportunities.&nbsp;0.2 mm layer height2 wall2.24 Inch width (57mm)Minimum infill needed -10%Orient model on side is best to print without supports.&nbsp;Will continue trials to check for possible improvements.

Print Profile(2)

Description

Comment & Rating (3)

The user shared this model, but is not the original creator of it.

License

Related Models