Search models, users, collections, and posts
A2L protective cover
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.4 h
2 plates
Open in Bambu Studio
Boost
0
1
0
0
0
0
Released
Description
Content has been automatically translated.
Because there is a desk with a water cup placed above the side of the printer, and the A2L Y-axis has vents on its right side, to prevent water from entering while not being too sealed, I designed a small dust cover. There are two shapes: semi-circular and triangular. The triangular one has not been tested, but it is very likely to be fine!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)