This is a dual print/lithophane combo! If you hold it up against a back light, it will glow in the dark (2nd picture attached). Great for placing in front of a tealight candle or some LED lights for some spooky Halloween vibes.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:
- PLA META Sunlu White Transmission Distance: 9.6
- PLA Overture Cream Transmission Distance: 8.4
- PLA+ eSun Grey Transmission Distance: 1.4
- PLA Siddament Black Transmission Distance: 0.2

Swap Instructions:
- Start with White
- At layer #21 (0.96mm) swap to Cream
- At layer #31 (1.36mm) swap to Grey
- At layer #42 (1.8mm) swap to Black for the rest.