Not sure if this will be useful to anyone. It's the little cone thing that is part of the extruder that comes with the Anycubic i3 Mega-S. I lost mine for awhile, and made this replacement. When I tried to pull it out after finding the original, it broke on a layer line and I had to pick the pieces out, so fair warning.

Check out my other Anycubic i3 Mega accessories at: https://www.printables.com/social/55222-tyler/collections/95780

If this design is useful to you, consider a tip or post a make!

Print instructions

Print Settings

Printer Brand: Anycubic
Rafts: Doesn't Matter
Resolution: 0.1

Notes: Small hole may or may not need to be adjusted with a drill bit. It will depend on your printer/material. It should scale up or down if necessary.

If this design was useful to you, please post a make!