Mr. Jack O. Lantern is expecting to come in to contact with many young unvaccinated
children this Halloween, so to protect him and his family I have supplied him with a mask
and a vaccine. I may have been a bit too late though. He has ended up with many green
warts. It seems he's already come down with something.

This syringe is a non-functional halloween prop. It has no moving parts. The plunger
piece prints separately from the rest of it. In my case it just snapped in nicely to the top,
but this will vary depending on your printer calibration. If it is too loose, a bit of krazy glue
or two part epoxy should do the trick. If it's too tight, you might need to do a bit of sanding.
For the "needle" at the end I held a finishing nail with a pair of pliers, heated up the end of
it with a lighter, and pushed it in to place.

Print Settings

Printer Brand:

Anycubic

Printer:

All-metal Mega

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20% hexagonal

Filament:
filaments.ca Econofil PLA White

If you liked this design, please post a make!