I have never played Secret Hitler, so everything was done at the direction of a friend of mine. They had some specifics requests to the Names/Characters so some of the Star Wars Lore doesn't line up properly, but I should have blanks of everything if anyone wants to make different characters.

I'm not great at modeling so this was done in Tinkercad and 3D Builder, so I'm sure some files might be janky, but everything printed well enough for me. You're milage may vary, but please feel free to fix my trash.

I printed with a textured PEI sheet to get the finish and used PLA Gloop to glue parts together. There are Glue Jigs in the files if anyone wants to go that route.

The Passports Inserts and Election Tracker are friction fit.

I used a Bambu Printer with the AMS to get the multi material parts going. I'm sure whatever flavor MMU would work with similar results.

For the Box I used 6mmx3mm magnets that friction fit in. If your tolerances are little tighter you can hand turn a drill bit to widen the holes some and glue in the magnets.

*I might do some more work on the Jedi Board in the future, its my least favorite part. The election tracker I used a smooth PEI sheet on the bottom of it so it turns with less friction. The textured side was too difficult to turn.

** I apologize for not being able to properly credit all the sites/artists that I used for reference/remixing for all the parts. The hard drive that had my asset spreadsheet got corrupted and I had only backed up the models.

I used https://www.font-generator.com/ to generate the fonts.

I'm going to try and track down everything again to properly credit everyone else's work, but in the mean time if you have any questions please don't hesitate to ask.

***After taking the photos I realized the “NO” card is upside down. Whoops.