Panda Den Insert - Version 2
Print Profile(1)
Description
A sorter vesion of the original Panda Den Insert. Thanks to @PhantomPlanet for pointing out and testing the shorter version.
I was annoyed about the amount of poop that jumped on the plate in panda den and landed outside the drawer. These poops are hard to remove again, so i created an insert for the Panda Den. Even when the inset is in place, you can still open the drawer, so you can empty it to wast.
It needs to be printed in TPU og TPU for AMS. (I have used the later) in order for the model to be flexible enough to come in and out of the Den it self.
The easiest way to install the inset, is to empty the drawer
place the inset in the middle of the drawer, and bend the to so you can close the drawer with the inset
After the inset is inside the Panda Den, slide it to the back. (This may require some bending of the bottom, in order to slide by the two screw holes)
I have printed this in 0.24 mm layer height in order to cut down time. But that is totally up to you.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)