Playing Cards Hardcase - Bridge Size Cards
Copyright Claim
Playing Cards Hardcase - Bridge Size Cards
Boost
47
88
26
Print Profile(4)
Standard print profile, 0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Both on 1 Plate, Gyroid 15% infill, 0.2mm layer, 3 walls,
1.6 h
1 plate
0.6mm nozzle, 0.18mm layer, 2 walls, 15% infill
1.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Boost
47
88
26
0
143
177
Released
Description
This is a model I've designed myself. As the model is not behind a paywall, support is appreciated!
https://www.buymeacoffee.com/Tridense
The case is made for bridge-size cards, so they will not fit poker-size ones
Bring the playing cards safely into your suitcase or backpack with a new plastic case that wont dissolve after a few uses!
Press on the sides of the top piece to release the lid
The model is also an improvement from all the feedback I got on my previous similar models.
Print at 0.2mm layer height
All the parts are pre-oriented for printability
Comment & Rating (26)
All
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
the fit is just a bit to tight, but it’s still functional
The designer has replied
0
Reply
Looks like you need to tune your filament profile
(Edited)1
Reply
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
Very nice print. Thanks much.
0
Reply
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
great design. maybe one for 32 cards would be also ok. thanks! PETG for caravan usage
0
Reply
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
perfekte Passform.
0
Reply
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
it a nice print but once I closed it I could not open it so maybe make it a little less tight.
The designer has replied
0
Reply
Try lowering flow rate
0
Reply
Print Profile
Both on 1 Plate, Gyroid 15% infill, 0.2mm layer, 3 walls,
works very well
0
Reply
Print Profile
Both on 1 Plate, Gyroid 15% infill, 0.2mm layer, 3 walls,
Thanks! Printed good in BL PetG
0
Reply
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
perfection
0
Reply
Print Profile
Standard print profile, 0.2mm layer, 2 walls, 15% infill
too tight
0
Reply
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld