Quick Retraction Test - 快速回缩测试 by 3DPrintinGreece.gr

3DPrintinGreece.gr

3D Printer>Test Models

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

Designer

16 min

1 plate

4.8(66)

Std. settings, 0.2mm layer, 2 walls, 2% infill

16 min

1 plate

4.8(9)

Open in Bambu Studio

Boost

214

1.2 k

2.2 k

Released

Description

Summary

A design to check your retraction. Quick print.

Greek Article: https://3dprintingreece.gr/retraction

Print Settings

Rafts:

Supports:

Resolution:

0.2

Infill:

anything

Adjusting Retraction Settings on Your Printer

To optimize your 3D printing results, it's essential to adjust the retraction settings, both in terms of length and speed. Here's how you can do it:

Set the retraction length between 0.5 to 1.5 mm/s. Start with a base value and adjust in increments of 0.5mm to see the effects.
The recommended retraction speed for direct drive is between 20-30 mm/s.

Experiment with these settings and observe the results to find the optimal configuration for your printer.

Comment & Rating (94)

@Codey

Boosted

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

Re printed to test silk PLA settings look good , tiny piece of stringing at the end which is fine by me

(Edited)

The designer has replied

@3DPrintinGreece

why 3 stars; is there any problem on the profile;

@Codey

Boosted

Replying to @3DPrintinGreece :

it wont let me rate above 3

@3DPrintinGreece

impossible. it still let you to edit it and change the stars. But it's up to you mate. No hard feelings.

@Hodzinets

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

Good

@eggheadcopilot

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

This test is helping me determine that the issue is probably wet filament or the temperature needs to be adjusted, since the others have much less stringing.