Quick Retraction Test by 3DPrintinGreece.gr

3DPrintinGreece.gr

3D Printer>Test Models

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

Designer

16 min

1 plate

4.7(51)

Std. settings, 0.2mm layer, 2 walls, 2% infill

16 min

1 plate

4.8(9)

Boost

168

919

2.1 k

Released

Description

Summary

A design to check your retraction. Quick print.

Greek Article: https://3dprintingreece.gr/retraction

Print Settings

Rafts:

Supports:

Resolution:

0.2

Infill:

anything

Adjusting Retraction Settings on Your Printer

To optimize your 3D printing results, it's essential to adjust the retraction settings, both in terms of length and speed. Here's how you can do it:

Set the retraction length between 0.5 to 1.5 mm/s. Start with a base value and adjust in increments of 0.5mm to see the effects.
The recommended retraction speed for direct drive is between 20-30 mm/s.

Experiment with these settings and observe the results to find the optimal configuration for your printer.

Comment & Rating (77)

@Codey

Boosted

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

Re printed to test silk PLA settings look good , tiny piece of stringing at the end which is fine by me

(Edited)

The designer has replied

@3DPrintinGreece

why 3 stars; is there any problem on the profile;

@Codey

Boosted

Replying to @3DPrintinGreece :

it wont let me rate above 3

@3DPrintinGreece

impossible. it still let you to edit it and change the stars. But it's up to you mate. No hard feelings.

@eggheadcopilot

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

This test is helping me determine that the issue is probably wet filament or the temperature needs to be adjusted, since the others have much less stringing.

@stefanoscarsi

Boosted

great test!

(Edited)

@mapr

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

Functional and demanding test

@Simone.perux

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

Strength Issue

The designer has replied

@3DPrintinGreece

why 2 stars; is there any problem on the profile;

@sandman89

Print Profile

Compatibility Settings - 0.2mm layer, 4 walls, 100% infill

decent test. went as expected.

The designer has replied

@3DPrintinGreece

so why the 3 stars?

(Edited)

@sandman89

Replying to @3DPrintinGreece :

3 stars is average. 4 is good. 5 is very good. it wasnt mind blowing, so 5 is out of the question. in comparison to other stress/calibration test it was alright but doesn't beat them. so average(3 stars) was an adequate rating. thank you for creating and posting it.