iPhone 15 pro bumper case by SHUNTARO

SHUNTARO

Fashion>Other Fashion Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

TPU 0.12mm layer, 6 walls, 100% infill

3.3 h

1 plate

5.0(1)

Boost

148

Released

Description

I decided to make my own iPhone case because I couldn't find one that I liked.

The hole for the switch is designed so that it can be easily pressed with a finger without being too large. Additionally, I added a shield for camera protection. This fits comfortably in the hand, enhancing grip.

I printed this using kexcelled's PLA and Bambu's PLA-CF. The molding turned out clean, except for areas with a 90° overhang.

iphone 15 pro

bumper

Comment & Rating (14)

@anthony.dhaene

printed well in TPU and PETG!

@Vergil

The print profile is no longer public

Good profile. Sadly I can’t put the phone into it though.

The designer has replied

@SHUNTARO

Thank you for your comment. First, slide the top of the iPhone in. Next, fit one side of the bottom. Finally, while pulling the case slightly, fit the other side to attach it. By following the steps in reverse, I was also able to remove it.

@Vergil

Replying to @SHUNTARO :

Hey! Thanks for the reply. I was afraid to push it that much, it felt like there was much more to bend or potentially break. ;D

@SHUNTARO

Replying to @Vergil :

You're right. Honestly, when I made this case, I wanted to use stuff like TPU, but it sucked that it didn’t work with AMS. I’m really hoping for a TPU that’s just the right stiffness to work with AMS. Thanks for checking out my post. Enjoy your 3D printing journey!

(Edited)