Simple Towel Hook
Copyright Claim
Simple Towel Hook
Boost
9
13
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
11 min
1 plate
Boost
9
13
5
0
31
25
Released
Description
Simple towel hook for hanging a towel from a hook.
Just squeez it in, and it sits firmly inside.
I printed it in PETG for some flex, might work just as well in PLA. If you think it's too narrow, just increase size a few percent.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works fine thanks.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Thanks for the model and profile. It did come out great! Printed some in PP and some in PLA. Both were just flexible enough to clamp properly around the towel.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld