CR-6 MAX Handle

This is a remix of the CR-6 SE Handle from here: https://www.thingiverse.com/thing:4755639

I needed a handle for my CR-6 Max where the screw holes are 86mm apart (slightly wider than the SE modle).

This design requires you to remove 2 screws and the spacers, insert the spacers into the holes and put the screws back in through the spacers and part. Takes less than a minute.

The spacers are 8mm and the holes are 8.2mm which is a nice tight fit.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament:Eryone PLA or PLA+ Red