Sunlu S2 Tabletop Tray
Remixed by
Copyright Claim
Sunlu S2 Tabletop Tray
Remixed by
Boost
8
24
16
Print Profile(1)
0.28mm layer, 3 walls, 15% infill
Designer
3.9 h
1 plate
Boost
8
24
16
0
68
35
Released
Description
My Sunlu S2 would sometimes tip over towards the extruder so I decided to use the original tray to hold the dryer next to my printer. Didn't need the holes to mount it so I filled them. It holds the Sunlu S2 perfectly on a table or something similar.
Comment & Rating (16)
All
Print Profile
0.28mm layer, 3 walls, 15% infill
Ok
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
perfectly fit !
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
corners lifted off a textured plate, with footprint of this base it should not have happened
The designer has replied
0
Reply
That hasn't happened to anyone else. Was the plate thoroughly cleaned before?
0
Reply
Yes
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
this is great my dryer fell over all the time no matter where i put it thank you
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
works great. very nice print.
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
Good fit. Added some anti slip pads underneath
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld