Soft Drinks Can Dispenser (UK cans)
Copyright Claim
Soft Drinks Can Dispenser (UK cans)
Boost
50
112
23
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
5.5 h
4 plates
Open in Bambu Studio
Boost
50
112
23
7
248
386
Released
Description
Drinks can dispenser sized for UK soft drink cans (330ml, ~66mm circumference and 125mm height).
This is my own design, created after difficulties finding or adapting an existing design for UK can sizes. Optimized for a 0.6mm nozzle (but probably printable just fine with 0.4mm).
Only requires some small supports for the pegs. Recommend the “Snug” setting in PrusaSlicer. Pegs are for alignment and you will need to super glue it together.
I… think… that Australia and New Zealand have the same sized cans, but I don't know that for sure.
I didn't print this on my Prusa Mini, but I think you could print one piece at a time on the Mini.
Comment & Rating (23)
All
Boosted
Thank you for this! Love it! I hope all is ok but I remixed a widener for beer...!
(Edited)
GIF
The designer has replied
1
Reply
Ha - I literally just posted a comment on your remix (before I saw this). Love it! Great work.
0
Reply
dutch cans also fits perfectly!
The designer has replied
1
Reply
Great to hear! :-)
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
dosnt take much material like other designs and works like a dream.
no problems with stuck cans or cans falling off at the back or the front
The designer has replied
1
Reply
Nice print! Thanks for posting a make
0
Reply
Boosted
Nice to have one of these for UK can sizes. Cheers!
1
Reply
Boosted
Print Profile
0.28mm layer, 2 walls, 15% infill
Easy print and assembly. I used CA glue and it worked first time.
1
Reply
The print profile is no longer public
It works great for cans
1
Reply
Boosted
Print Profile
0.28mm layer, 2 walls, 15% infill
Had some problems with pins not connecting some holes, but a bit of glue always work
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
The profile profile is perfect. For the design, It is suggested that interference fit the shaft and hole instead of using glue.
0
Reply
The print profile is no longer public
2
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld