This is a version of my phone stand that I made a couple years ago that allows you to insert an Apple magsafe charger for wireless charging capability. Personally I just have the charger sitting in the cutout, but it doesn't fit super tightly so if you want to be extra safe you may want to try sticking it in place with some thin double sided tape. (I think I've seen it sold at home depot as double sided carpet tape)

If you don't care about the wireless charging aspect of this, the non-charging version can be found here:

https://www.printables.com/model/51601-phone-stand

If you don't care about the wireless charging aspect of this AND you have a popsocket case, try this one:

https://www.printables.com/model/166210-phone-stand-for-popsockets

This charging stand was tested mostly with a Samsung Galaxy S21 FE. It worked with that, but I imagine if your device is a significantly different size it may not line up correctly with where I have the charger positioned.

This phone stand should be printed sideways (how it is already positioned in the STL) at a layer height of 0.3. Automatic support generation should be enabled. There are also some optional TPU feet to glue on the bottom if you'd like.