Suspended Hand - Fully Colorized
Remixed by
Copyright Claim
Suspended Hand - Fully Colorized
Remixed by
Boost
60
107
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
18.2 h
1 plate
Boost
60
107
16
1
195
61
Released
Description
This is a fully colorized version of the Suspended Hand model.
This is a hand-painted coloration of the original, isolating three separate colors. All of the little pockets have been hand painted, so there's no color bleed.
All credit goes to the original author - be sure to check out some of his other work: STomHacks. All I did was do some tedious painting, so you don't have to. :)
The original licensing model is still in effect - please refer to this link: https://creativecommons.org/licenses/by-nc-sa/4.0/
Comment & Rating (16)
All
Works great, just had to reprint the blade in tough PLA to keep the tabs intact.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This was my first multicolor print and I used non bambu PLA and generic settings, the print came out astounding.
The designer has replied
1
Reply
Awesome!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
chose two color - heavy swap between means a good amount of ‘waste’ / but the product and finish are worth it! great item
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Profile prints perfectly.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great. Friends love it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I ran out of filament at the end so couldn’t finish the print. But other than that it was great model and I would print it many more times. 5 stars if I could.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld