Large Vase
Copyright Claim
Large Vase
Boost
152
236
41
Print Profile(1)
PLA, 0.2mm layer, 1 walls, 0% infill
1.8 h
1 plate
Boost
152
236
41
0
405
303
Released
Description
Large Vase I made for some lego flowers. looks really nice in Matte filament in my opinion.
Prints well in the 0.2mm Strength setting with a 0.4mm nozzle. Id suggest downloading the STL and scaling/setting up the print to suit your preferences.
Comment & Rating (41)
All
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
nice design but the bottom is to thin. separates from the walls if you flex it. printed with petg
0
Reply
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
Prints great, Thanks for the file!
0
Reply
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
beautiful and fast!
0
Reply
Printed well! but be careful when taking it off the bed, as I almost pulled the bottom off
0
Reply
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
le rendu est super beau
0
Reply
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
perfekt
(Edited)
0
Reply
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
Strength Issue:only single wall, it’s so flexible that you ends on top to each other.
Other Issues:overhang make the bottom not watertight, a lot of small holes, would be solved with higher base or 2 wall parameters
0
Reply
In general, PLA is not watertight as it always has some gaps between layers; increasing the base or layers doesn't really solve it. Also, having water in a 'PLA vase' for too long will make the PLA soft and thus not watertight anyway.
OP's vase is, as mentioned, perfect for Lego flowers.
0
Reply
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
PLA, 0.2mm layer, 1 walls, 0% infill
0
Reply
Exactly what i was looking for. Got the lego set for gf.
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld