Bambu Lab P1P Poop Chute for ARC Enclosure
Copyright Claim
Bambu Lab P1P Poop Chute for ARC Enclosure
Boost
45
69
25
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
Designer
8.2 h
1 plate
Boost
45
69
25
1
308
103
Released
Description
Poop Chute for Bambu Lab P1P with ARC enclosure.
Height of chute is calculated with 10mm washer antivibration mat.
Additional file is 8mm lower for those without antivibration mat.
Used 3 magnets for better holding to back. Place for magnets is 10x10x3mm.
Comment & Rating (25)
All
Print Profile
0.2mm layer, 2 walls, 30% infill
noch nie sowas schönes gedruckt
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
perfecto
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
Perfect print on the first try
0
Reply
does it fit for x1c?
The designer has replied
0
Reply
It was not design for X1C.
1
Reply
Replying to @Szaman
thank you anyway 👍🏼
1
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
no problems at all!
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
sehr gutes Druckmodell, kann ich nur weiterempfehlen
0
Reply
Super Ergebnis
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
works good catches my filiment poop and keeps it off the floor
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
Prints perrrrrrfect!
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld